东莞招聘

Main Mission :

As the key member of project team, you will be as draftsman and adjuster for press dies and checking jigs and will be involved into supplier qualification, negotiation, selection, schedule following-up and final design confirmer based on support from France technical team. It is really important to working with suppliers with achievable of cost objective, timing planning and quality control.


Knowledge wished:

* Reading of plan / DFN

* Symbol of tolerance (ISO specifications)

* Drawing, GD&T (General Dimension and Tolerance)

* RPS (Reference Point System)

* Understanding of a control report

* Planning follow up

* Evaluation of time realisation

* Steel and heat treatment

* Microsoft pack

Possible Training Programme

* Use of a machine of three-dimensional control (put in references, put the checking fixture into the X,Y,Z coordinates vehicle)

* Use of control software

* Press dies and checking fixtures acceptance (buy off)

* French and English improvement lesson



Job Requirements (skills and experience)

- Bachelor degree or above major in engineering, understanding of press dies and checking jigs knowledge is plus.

- Minimum 3 years working experience of automotive product engineering or design engineering

- Good presentation, communication and interpersonal skills
- High integrity with motivation, can work independently with limited supervision,
- English indispensable, French is plus.

-Willing to frequent travel domestic and abroad based on project request

斯诺浦汽车部件（广州）有限公司总部位于法国，致力于为原始设备制造商提供专业的冲压技术、装配件的制作和生产，是汽车行业中重要的一级供应商。公司始终坚持以“雄心、透明、利益、专业、尊重、信任”为服务理念，以高新技术与品牌打造企业。

斯诺浦汽车部件（广州）有限公司于2012年3月份在广州投产，投资额为2亿人民币。目前的客户有：长安标致雪铁龙，雷诺日产，江铃福特，广汽及比亚迪。基于我们的特殊技术，中国市场将是我们重要的发展方向。